Prusa3D Forum

Notifications

Clear all

zcassell

Grupa: Zarejestrowany

Dołączył: 2018/05/13

Active Member

	Ok, leaving it heated up for 15 minutes worked perfectly. Th... In forum Hardware, firmware and software help	6 years temu
	So I got the heater block tightened by removing the fans and... In forum Hardware, firmware and software help	6 years temu
	Thanks for replying. I did try to rotate the nozzle in both ... In forum Hardware, firmware and software help	6 years temu
	Can't remove nozzle on mk3 In forum Hardware, firmware and software help	6 years temu
	Ok so after talking with support they concluded that I had a... In forum Hardware, firmware and software help	6 years temu
	Ok, so I figured some things out. Tech support told me to ta... In forum Hardware, firmware and software help	6 years temu
	Thanks so much for the help! I'm not good with electronics ... In forum Hardware, firmware and software help	6 years temu
	UPDATE: Here's some things I figured out and didn't mention... In forum Hardware, firmware and software help	6 years temu
	Y axis length selftest error In forum Hardware, firmware and software help	6 years temu

Statystyki Forum

565 Fora

63.8 K Tematy

447.3 K Posty

21 Online

69.3 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte