Prusa3D Forum

Benachrichtigungen

Alles löschen

zcassell

Gruppe: Registriert

Beigetreten: 2018/05/13

Active Member

	Ok, leaving it heated up for 15 minutes worked perfectly. Th... Im Forum Hardware, firmware and software help	Vor 6 years
	So I got the heater block tightened by removing the fans and... Im Forum Hardware, firmware and software help	Vor 6 years
	Thanks for replying. I did try to rotate the nozzle in both ... Im Forum Hardware, firmware and software help	Vor 6 years
	Can't remove nozzle on mk3 Im Forum Hardware, firmware and software help	Vor 6 years
	Ok so after talking with support they concluded that I had a... Im Forum Hardware, firmware and software help	Vor 6 years
	Ok, so I figured some things out. Tech support told me to ta... Im Forum Hardware, firmware and software help	Vor 6 years
	Thanks so much for the help! I'm not good with electronics ... Im Forum Hardware, firmware and software help	Vor 6 years
	UPDATE: Here's some things I figured out and didn't mention... Im Forum Hardware, firmware and software help	Vor 6 years
	Y axis length selftest error Im Forum Hardware, firmware and software help	Vor 6 years

Forums-Statistiken

565 Foren

63.8 K Themen

447.3 K Beiträge

22 Online

69.3 K Mitglieder

Forum Icons: Das Forum enthält keine ungelesenen Beiträge Das Forum enthält ungelesene Beiträge

Themen-Icons: Unbeantwortet Beantwortet Aktiv Heiß Oben angepinnt Nicht genehmigt Gelöst Privat Geschlossen