Prusa3D Forum

Notifications

Clear all

zcassell

Skupina: Registrovaný

Přidal se: 2018/05/13

Active Member

	Ok, leaving it heated up for 15 minutes worked perfectly. Th... In forum Hardware, firmware and software help	před 6 years
	So I got the heater block tightened by removing the fans and... In forum Hardware, firmware and software help	před 6 years
	Thanks for replying. I did try to rotate the nozzle in both ... In forum Hardware, firmware and software help	před 6 years
	Can't remove nozzle on mk3 In forum Hardware, firmware and software help	před 6 years
	Ok so after talking with support they concluded that I had a... In forum Hardware, firmware and software help	před 6 years
	Ok, so I figured some things out. Tech support told me to ta... In forum Hardware, firmware and software help	před 6 years
	Thanks so much for the help! I'm not good with electronics ... In forum Hardware, firmware and software help	před 6 years
	UPDATE: Here's some things I figured out and didn't mention... In forum Hardware, firmware and software help	před 6 years
	Y axis length selftest error In forum Hardware, firmware and software help	před 6 years

Fórum Statistiky

565 Fóra

63.8 K Témata

447.3 K Příspěvky

21 Online

69.3 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed