Prusa3D Forum

Notifiche

Cancella tutti

zcassell

Gruppo: Registrato

Registrato: 2018/05/13

Active Member

	Ok, leaving it heated up for 15 minutes worked perfectly. Th... Nel forum Hardware, firmware and software help	7 years fa
	So I got the heater block tightened by removing the fans and... Nel forum Hardware, firmware and software help	7 years fa
	Thanks for replying. I did try to rotate the nozzle in both ... Nel forum Hardware, firmware and software help	7 years fa
	Can't remove nozzle on mk3 Nel forum Hardware, firmware and software help	7 years fa
	Ok so after talking with support they concluded that I had a... Nel forum Hardware, firmware and software help	7 years fa
	Ok, so I figured some things out. Tech support told me to ta... Nel forum Hardware, firmware and software help	7 years fa
	Thanks so much for the help! I'm not good with electronics ... Nel forum Hardware, firmware and software help	7 years fa
	UPDATE: Here's some things I figured out and didn't mention... Nel forum Hardware, firmware and software help	7 years fa
	Y axis length selftest error Nel forum Hardware, firmware and software help	7 years fa

Statistiche Forum

585 Forum

68.2 K Discussioni

477.8 K Post

14 Online

75.9 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso