Prusa3D Forum

Notifications

Clear all

zcassell

Groupe: Enregistré

A(ont) rejoint: 2018/05/13

Active Member

	Ok, leaving it heated up for 15 minutes worked perfectly. Th... Dans le forum Hardware, firmware and software help	il y a 6 years
	So I got the heater block tightened by removing the fans and... Dans le forum Hardware, firmware and software help	il y a 6 years
	Thanks for replying. I did try to rotate the nozzle in both ... Dans le forum Hardware, firmware and software help	il y a 6 years
	Can't remove nozzle on mk3 Dans le forum Hardware, firmware and software help	il y a 6 years
	Ok so after talking with support they concluded that I had a... Dans le forum Hardware, firmware and software help	il y a 6 years
	Ok, so I figured some things out. Tech support told me to ta... Dans le forum Hardware, firmware and software help	il y a 6 years
	Thanks so much for the help! I'm not good with electronics ... Dans le forum Hardware, firmware and software help	il y a 6 years
	UPDATE: Here's some things I figured out and didn't mention... Dans le forum Hardware, firmware and software help	il y a 6 years
	Y axis length selftest error Dans le forum Hardware, firmware and software help	il y a 6 years

Statistiques du forum

565 Forums

63.8 K Sujets

447.3 K Messages

22 En-ligne

69.3 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé