Prusa3D Forum

Avisos

Vaciar todo

zcassell

Grupo: Registrado

Registrado: 2018/05/13

Active Member

	Ok, leaving it heated up for 15 minutes worked perfectly. Th... En el foro Hardware, firmware and software help	hace 7 years
	So I got the heater block tightened by removing the fans and... En el foro Hardware, firmware and software help	hace 7 years
	Thanks for replying. I did try to rotate the nozzle in both ... En el foro Hardware, firmware and software help	hace 7 years
	Can't remove nozzle on mk3 En el foro Hardware, firmware and software help	hace 7 years
	Ok so after talking with support they concluded that I had a... En el foro Hardware, firmware and software help	hace 7 years
	Ok, so I figured some things out. Tech support told me to ta... En el foro Hardware, firmware and software help	hace 7 years
	Thanks so much for the help! I'm not good with electronics ... En el foro Hardware, firmware and software help	hace 7 years
	UPDATE: Here's some things I figured out and didn't mention... En el foro Hardware, firmware and software help	hace 7 years
	Y axis length selftest error En el foro Hardware, firmware and software help	hace 7 years

Estadísticas del Foro

585 Foros

68.2 K Temas

477.9 K Respuestas

11 En línea

75.9 K Miembros

Iconos del foro: El foro no contiene publicaciones sin leer El foro contiene publicaciones sin leer

Iconos de los Temas: No respondidos Respondido Activo Popular Fijo No aprobados Resuelto Privado Cerrado