Activity
 
Notifications
Clear all
xenon
xenon
Group: Registered
Joined: 2021/06/09
Trusted Member
3
can be done with modifiers.

In forum Hardware, firmware and software help

2 weeks ago
improving & reducing travel moves

In forum PrusaSlicer

2 weeks ago
funny you think this is an oversight. if you don't like it y...

In forum Assembly and first prints troubleshooting

3 weeks ago
tightened the screws a bit too much so it deformed the pipe?

In forum Hardware, firmware and software help

1 month ago
rock them back and forth under screw tension to help seat th...

In forum Assembly and first prints troubleshooting

1 month ago
if the plastics piece is designed to show 3,5Nm, better stil...

In forum Assembly and first prints troubleshooting

1 month ago
tried the livechat? takes a while to get through, depending ...

In forum Hardware, firmware and software help

1 month ago
tighten the grub screws on the pulleys? i doubt the belt sli...

In forum Hardware, firmware and software help

1 month ago
copy them, add xl to the new name, and set lower temperature...

In forum Assembly and first prints troubleshooting

1 month ago
had the same issue during assembly but so far it didnt affec...

In forum Assembly and first prints troubleshooting

1 month ago
bed leveling issues: - check that the bed is (mostly) leve...

In forum Hardware, firmware and software help

2 months ago
it is quite a shame. so many pixels and so little info shown

In forum Assembly and first prints troubleshooting

2 months ago
plus you can skip it if you only have a small part or know i...

In forum Assembly and first prints troubleshooting

2 months ago
my guess the wait is there so the metal frame of the heatbed...

In forum Assembly and first prints troubleshooting

2 months ago
still sounds like leadscrew noise to me. you could try rem...

In forum Hardware, firmware and software help

2 months ago
sounds a bit more like it is the lead screw. maybe try lubin...

In forum Hardware, firmware and software help

2 months ago
as long as the markings are only grease it doesnt matter - t...

In forum Hardware, firmware and software help

2 months ago
yeah the bed was mostly cooled down, but from my experience ...

In forum Hardware, firmware and software help

2 months ago
Page 1 / 4
Share: