Polski
Fora
Członkowie
SloppyPuppy
Aktywność
 
Notifications
Clear all
SloppyPuppy
SloppyPuppy
Grupa: Zarejestrowany
Dołączył: 2015/10/19
Active Member
1
Profil Aktywność
Ohh I see I was looking at this place for the parts and o...

In forum General discussion, announcements and releases

 6 years temu
Original SCAD or Fusion 360 models of the MMU

In forum General discussion, announcements and releases

 6 years temu
Try a factory reset and then try to load the correct firmwar...

In forum Hardware, firmware and software help

 7 years temu
updated the wrong firmware on MK2S and now its stuck

In forum Hardware, firmware and software help

 7 years temu
yall are way too over killing it. just place small cubes of...

In forum Others (Archive)

 9 years temu
Eventually I think I solved it by reinstalling the firmware ...

In forum Prusa i3 kit (Archive)

 9 years temu
Hi, can someone please help me with this issue? I dont know ...

In forum Prusa i3 kit (Archive)

 9 years temu
In Firmware 3.0.6 there is the possibility to adjust the cal...

In forum Prusa i3 kit (Archive)

 9 years temu
In Firmware 3.0.6 there is the possibility to adjust the cal...

In forum Prusa i3 kit (Archive)

 9 years temu
Printing bed is not straight sometimes on MK2

In forum Prusa i3 kit (Archive)

 9 years temu
Center of bed is closer to nozzle than the corners

In forum Prusa i3 kit (Archive)

 10 years temu
So I found the best way to do this. its called modifier mash...

In forum Print tips (Archive)

 10 years temu
How can I have some parts in a print 100% filled but other p...

In forum Print tips (Archive)

 10 years temu
Just wanted to update. apparently what I did wrong was the s...

In forum Prusa i3 kit (Archive)

 10 years temu
I think this is normal behavior. ABS expands when is heated....

In forum Prusa i3 kit (Archive)

 10 years temu
ABS coming out of extruder when not doing anything

In forum Prusa i3 kit (Archive)

 10 years temu
Share: