Español
Foros
Miembros
SloppyPuppy
Actividad
 
Avisos
Vaciar todo
SloppyPuppy
SloppyPuppy
Grupo: Registrado
Registrado: 2015/10/19
Active Member
1
Perfil Actividad
Ohh I see I was looking at this place for the parts and o...

En el foro General discussion, announcements and releases

 hace 6 years
Original SCAD or Fusion 360 models of the MMU

En el foro General discussion, announcements and releases

 hace 6 years
Try a factory reset and then try to load the correct firmwar...

En el foro Hardware, firmware and software help

 hace 7 years
updated the wrong firmware on MK2S and now its stuck

En el foro Hardware, firmware and software help

 hace 7 years
yall are way too over killing it. just place small cubes of...

En el foro Others (Archive)

 hace 9 years
Eventually I think I solved it by reinstalling the firmware ...

En el foro Prusa i3 kit (Archive)

 hace 9 years
Hi, can someone please help me with this issue? I dont know ...

En el foro Prusa i3 kit (Archive)

 hace 9 years
In Firmware 3.0.6 there is the possibility to adjust the cal...

En el foro Prusa i3 kit (Archive)

 hace 9 years
In Firmware 3.0.6 there is the possibility to adjust the cal...

En el foro Prusa i3 kit (Archive)

 hace 9 years
Printing bed is not straight sometimes on MK2

En el foro Prusa i3 kit (Archive)

 hace 9 years
Center of bed is closer to nozzle than the corners

En el foro Prusa i3 kit (Archive)

 hace 10 years
So I found the best way to do this. its called modifier mash...

En el foro Print tips (Archive)

 hace 10 years
How can I have some parts in a print 100% filled but other p...

En el foro Print tips (Archive)

 hace 10 years
Just wanted to update. apparently what I did wrong was the s...

En el foro Prusa i3 kit (Archive)

 hace 10 years
I think this is normal behavior. ABS expands when is heated....

En el foro Prusa i3 kit (Archive)

 hace 10 years
ABS coming out of extruder when not doing anything

En el foro Prusa i3 kit (Archive)

 hace 10 years
Compartir: