Prusa3D Forum

Notifications

Clear all

SloppyPuppy

Groupe: Enregistré

A(ont) rejoint: 2015/10/19

Active Member

	Ohh I see I was looking at this place for the parts and o... Dans le forum General discussion, announcements and releases	il y a 5 years
	Original SCAD or Fusion 360 models of the MMU Dans le forum General discussion, announcements and releases	il y a 5 years
	Try a factory reset and then try to load the correct firmwar... Dans le forum Hardware, firmware and software help	il y a 6 years
	updated the wrong firmware on MK2S and now its stuck Dans le forum Hardware, firmware and software help	il y a 6 years
	yall are way too over killing it. just place small cubes of... Dans le forum Others (Archive)	il y a 8 years
	Eventually I think I solved it by reinstalling the firmware ... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	Hi, can someone please help me with this issue? I dont know ... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	In Firmware 3.0.6 there is the possibility to adjust the cal... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	In Firmware 3.0.6 there is the possibility to adjust the cal... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	Printing bed is not straight sometimes on MK2 Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	Center of bed is closer to nozzle than the corners Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	So I found the best way to do this. its called modifier mash... Dans le forum Print tips (Archive)	il y a 9 years
	How can I have some parts in a print 100% filled but other p... Dans le forum Print tips (Archive)	il y a 9 years
	Just wanted to update. apparently what I did wrong was the s... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	I think this is normal behavior. ABS expands when is heated.... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	ABS coming out of extruder when not doing anything Dans le forum Prusa i3 kit (Archive)	il y a 9 years

Statistiques du forum

565 Forums

63.6 K Sujets

446.2 K Messages

19 En-ligne

68.9 K Membres

Le dernier des messages: Repeated Probing on right side of bed Notre nouveau membre: Kiley Murphy Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé