Čeština
Fóra
Uživatelé
SloppyPuppy
Aktivita
 
Notifications
Clear all
SloppyPuppy
SloppyPuppy
Skupina: Registrovaný
Přidal se: 2015/10/19
Active Member
1
Profile Aktivita
Ohh I see I was looking at this place for the parts and o...

In forum General discussion, announcements and releases

 před 6 years
Original SCAD or Fusion 360 models of the MMU

In forum General discussion, announcements and releases

 před 6 years
Try a factory reset and then try to load the correct firmwar...

In forum Hardware, firmware and software help

 před 7 years
updated the wrong firmware on MK2S and now its stuck

In forum Hardware, firmware and software help

 před 7 years
yall are way too over killing it. just place small cubes of...

In forum Others (Archive)

 před 9 years
Eventually I think I solved it by reinstalling the firmware ...

In forum Prusa i3 kit (Archive)

 před 9 years
Hi, can someone please help me with this issue? I dont know ...

In forum Prusa i3 kit (Archive)

 před 9 years
In Firmware 3.0.6 there is the possibility to adjust the cal...

In forum Prusa i3 kit (Archive)

 před 9 years
In Firmware 3.0.6 there is the possibility to adjust the cal...

In forum Prusa i3 kit (Archive)

 před 9 years
Printing bed is not straight sometimes on MK2

In forum Prusa i3 kit (Archive)

 před 9 years
Center of bed is closer to nozzle than the corners

In forum Prusa i3 kit (Archive)

 před 10 years
So I found the best way to do this. its called modifier mash...

In forum Print tips (Archive)

 před 10 years
How can I have some parts in a print 100% filled but other p...

In forum Print tips (Archive)

 před 10 years
Just wanted to update. apparently what I did wrong was the s...

In forum Prusa i3 kit (Archive)

 před 10 years
I think this is normal behavior. ABS expands when is heated....

In forum Prusa i3 kit (Archive)

 před 10 years
ABS coming out of extruder when not doing anything

In forum Prusa i3 kit (Archive)

 před 10 years
Share: