Prusa3D Forum

Notifications

Clear all

Semi

Groupe: Enregistré

A(ont) rejoint: 2022/02/08

Active Member

	Random: Any reason this is still stickied to the top of the ... Dans le forum PrusaSlicer	il y a 1 year
	Random question about how slicer generates supports Dans le forum PrusaSlicer	il y a 1 year
	Same issue here. It works every now and then, and if I look ... Dans le forum Bugs & Errors	il y a 1 year
	I can try drying again. Mine is about a 2 months old. Ordere... Dans le forum How do I print this? (Printing help)	il y a 2 years
	That is why I have been too scared to try it on my PEI sheet... Dans le forum How do I print this? (Printing help)	il y a 2 years
	I saw 17/04.. didn't see the year. Thanks for the quick resp... Dans le forum How do I print this? (Printing help)	il y a 2 years
	I have the same problem. Satin sheet. Textured sheet, dried ... Dans le forum How do I print this? (Printing help)	il y a 2 years
	And correct you are! I had download the newer version this m... Dans le forum PrusaSlicer	il y a 3 years
	OK.. so that then DOES make sense, and I'm a lot less confus... Dans le forum PrusaSlicer	il y a 3 years
	[Confused] PrusaSlicer says model is to big Dans le forum PrusaSlicer	il y a 3 years
	Thanks all.Took 12.5 hours to assemble (I was streaming it a... Dans le forum General discussion, announcements and releases	il y a 4 years
	Thanks @diem and @Bob. I did a bit of research a few years a... Dans le forum General discussion, announcements and releases	il y a 4 years
	Newbie filament recommendations Dans le forum General discussion, announcements and releases	il y a 4 years

Statistiques du forum

585 Forums

68.1 K Sujets

477.2 K Messages

17 En-ligne

75.8 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé