Prusa3D Forum

Notifications

Clear all

Semi

Skupina: Registrovaný

Přidal se: 2022/02/08

Active Member

	Random: Any reason this is still stickied to the top of the ... In forum PrusaSlicer	před 1 year
	Random question about how slicer generates supports In forum PrusaSlicer	před 1 year
	Same issue here. It works every now and then, and if I look ... In forum Bugs & Errors	před 1 year
	I can try drying again. Mine is about a 2 months old. Ordere... In forum How do I print this? (Printing help)	před 2 years
	That is why I have been too scared to try it on my PEI sheet... In forum How do I print this? (Printing help)	před 2 years
	I saw 17/04.. didn't see the year. Thanks for the quick resp... In forum How do I print this? (Printing help)	před 2 years
	I have the same problem. Satin sheet. Textured sheet, dried ... In forum How do I print this? (Printing help)	před 2 years
	And correct you are! I had download the newer version this m... In forum PrusaSlicer	před 3 years
	OK.. so that then DOES make sense, and I'm a lot less confus... In forum PrusaSlicer	před 3 years
	[Confused] PrusaSlicer says model is to big In forum PrusaSlicer	před 3 years
	Thanks all.Took 12.5 hours to assemble (I was streaming it a... In forum General discussion, announcements and releases	před 4 years
	Thanks @diem and @Bob. I did a bit of research a few years a... In forum General discussion, announcements and releases	před 4 years
	Newbie filament recommendations In forum General discussion, announcements and releases	před 4 years

Fórum Statistiky

585 Fóra

68.1 K Témata

477.1 K Příspěvky

11 Online

75.7 K Uživatelé

Poslední Příspěvek: edges curl Nový Uživatel: Tommy Recent Posts Unread Posts Tags

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed