Prusa3D Forum

Notifications

Clear all

MPJ

Grupa: Zarejestrowany

Dołączył: 2017/04/12

Active Member

	One way to adjust this is to loosen the black top nut on the... In forum Prusa i3 kit (Archive)	7 years temu
	You might be past this solution, but when mine was blocked i... In forum Prusa i3 kit (Archive)	8 years temu
	I used the provided gcode and all I did was turn the tempera... In forum Awesome prints (Hall Of Fame)	8 years temu
	I think bottom side turned out very good, don't see that sam... In forum Awesome prints (Hall Of Fame)	8 years temu
	Fixed post above with image. Worked when I used preview, but... In forum Awesome prints (Hall Of Fame)	8 years temu
	Here is my attempt, and by that I mean using the provided gc... In forum Awesome prints (Hall Of Fame)	8 years temu
	Thanks for the camera holder. I printed the spool holder and... In forum Improvements (Archive)	8 years temu
	Great job, simple and effective...on a side note, where did ... In forum Improvements (Archive)	8 years temu
	Not trying to jump in on this thread, but you were asking ab... In forum Prusa i3 kit (Archive)	8 years temu
	I have the same issue using pronterface. I will set the new ... In forum Prusa i3 kit (Archive)	8 years temu
	Are you sure the left side rod is pushed into the slot? The ... In forum Prusa i3 kit (Archive)	8 years temu
	Going to assume this is new. I had same issue and was also a... In forum Prusa i3 kit (Archive)	8 years temu
	Extruder Fan Wiring Error In forum Prusa i3 kit (Archive)	8 years temu

Statystyki Forum

565 Fora

63.8 K Tematy

447.3 K Posty

21 Online

69.4 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte