Prusa3D Forum

Benachrichtigungen

Alles löschen

MPJ

Gruppe: Registriert

Beigetreten: 2017/04/12

Active Member

	One way to adjust this is to loosen the black top nut on the... Im Forum Prusa i3 kit (Archive)	Vor 7 years
	You might be past this solution, but when mine was blocked i... Im Forum Prusa i3 kit (Archive)	Vor 8 years
	I used the provided gcode and all I did was turn the tempera... Im Forum Awesome prints (Hall Of Fame)	Vor 8 years
	I think bottom side turned out very good, don't see that sam... Im Forum Awesome prints (Hall Of Fame)	Vor 8 years
	Fixed post above with image. Worked when I used preview, but... Im Forum Awesome prints (Hall Of Fame)	Vor 8 years
	Here is my attempt, and by that I mean using the provided gc... Im Forum Awesome prints (Hall Of Fame)	Vor 8 years
	Thanks for the camera holder. I printed the spool holder and... Im Forum Improvements (Archive)	Vor 8 years
	Great job, simple and effective...on a side note, where did ... Im Forum Improvements (Archive)	Vor 8 years
	Not trying to jump in on this thread, but you were asking ab... Im Forum Prusa i3 kit (Archive)	Vor 8 years
	I have the same issue using pronterface. I will set the new ... Im Forum Prusa i3 kit (Archive)	Vor 8 years
	Are you sure the left side rod is pushed into the slot? The ... Im Forum Prusa i3 kit (Archive)	Vor 8 years
	Going to assume this is new. I had same issue and was also a... Im Forum Prusa i3 kit (Archive)	Vor 8 years
	Extruder Fan Wiring Error Im Forum Prusa i3 kit (Archive)	Vor 8 years

Forums-Statistiken

565 Foren

63.8 K Themen

447.3 K Beiträge

22 Online

69.4 K Mitglieder

Forum Icons: Das Forum enthält keine ungelesenen Beiträge Das Forum enthält ungelesene Beiträge

Themen-Icons: Unbeantwortet Beantwortet Aktiv Heiß Oben angepinnt Nicht genehmigt Gelöst Privat Geschlossen