Prusa3D Forum

Notifiche

Cancella tutti

MPJ

Gruppo: Registrato

Registrato: 2017/04/12

Active Member

	One way to adjust this is to loosen the black top nut on the... Nel forum Prusa i3 kit (Archive)	7 years fa
	You might be past this solution, but when mine was blocked i... Nel forum Prusa i3 kit (Archive)	8 years fa
	I used the provided gcode and all I did was turn the tempera... Nel forum Awesome prints (Hall Of Fame)	8 years fa
	I think bottom side turned out very good, don't see that sam... Nel forum Awesome prints (Hall Of Fame)	8 years fa
	Fixed post above with image. Worked when I used preview, but... Nel forum Awesome prints (Hall Of Fame)	8 years fa
	Here is my attempt, and by that I mean using the provided gc... Nel forum Awesome prints (Hall Of Fame)	8 years fa
	Thanks for the camera holder. I printed the spool holder and... Nel forum Improvements (Archive)	8 years fa
	Great job, simple and effective...on a side note, where did ... Nel forum Improvements (Archive)	8 years fa
	Not trying to jump in on this thread, but you were asking ab... Nel forum Prusa i3 kit (Archive)	8 years fa
	I have the same issue using pronterface. I will set the new ... Nel forum Prusa i3 kit (Archive)	8 years fa
	Are you sure the left side rod is pushed into the slot? The ... Nel forum Prusa i3 kit (Archive)	8 years fa
	Going to assume this is new. I had same issue and was also a... Nel forum Prusa i3 kit (Archive)	8 years fa
	Extruder Fan Wiring Error Nel forum Prusa i3 kit (Archive)	8 years fa

Statistiche Forum

565 Forum

63.8 K Discussioni

447.3 K Post

21 Online

69.4 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso