Prusa3D Forum

Avisos

Vaciar todo

MPJ

Grupo: Registrado

Registrado: 2017/04/12

Active Member

	One way to adjust this is to loosen the black top nut on the... En el foro Prusa i3 kit (Archive)	hace 7 years
	You might be past this solution, but when mine was blocked i... En el foro Prusa i3 kit (Archive)	hace 8 years
	I used the provided gcode and all I did was turn the tempera... En el foro Awesome prints (Hall Of Fame)	hace 8 years
	I think bottom side turned out very good, don't see that sam... En el foro Awesome prints (Hall Of Fame)	hace 8 years
	Fixed post above with image. Worked when I used preview, but... En el foro Awesome prints (Hall Of Fame)	hace 8 years
	Here is my attempt, and by that I mean using the provided gc... En el foro Awesome prints (Hall Of Fame)	hace 8 years
	Thanks for the camera holder. I printed the spool holder and... En el foro Improvements (Archive)	hace 8 years
	Great job, simple and effective...on a side note, where did ... En el foro Improvements (Archive)	hace 8 years
	Not trying to jump in on this thread, but you were asking ab... En el foro Prusa i3 kit (Archive)	hace 8 years
	I have the same issue using pronterface. I will set the new ... En el foro Prusa i3 kit (Archive)	hace 8 years
	Are you sure the left side rod is pushed into the slot? The ... En el foro Prusa i3 kit (Archive)	hace 8 years
	Going to assume this is new. I had same issue and was also a... En el foro Prusa i3 kit (Archive)	hace 8 years
	Extruder Fan Wiring Error En el foro Prusa i3 kit (Archive)	hace 8 years

Estadísticas del Foro

565 Foros

63.8 K Temas

447.3 K Respuestas

21 En línea

69.4 K Miembros

Iconos del foro: El foro no contiene publicaciones sin leer El foro contiene publicaciones sin leer

Iconos de los Temas: No respondidos Respondido Activo Popular Fijo No aprobados Resuelto Privado Cerrado