Prusa3D Forum

Notifications

Clear all

MPJ

Groupe: Enregistré

A(ont) rejoint: 2017/04/12

Active Member

	One way to adjust this is to loosen the black top nut on the... Dans le forum Prusa i3 kit (Archive)	il y a 7 years
	You might be past this solution, but when mine was blocked i... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	I used the provided gcode and all I did was turn the tempera... Dans le forum Awesome prints (Hall Of Fame)	il y a 8 years
	I think bottom side turned out very good, don't see that sam... Dans le forum Awesome prints (Hall Of Fame)	il y a 8 years
	Fixed post above with image. Worked when I used preview, but... Dans le forum Awesome prints (Hall Of Fame)	il y a 8 years
	Here is my attempt, and by that I mean using the provided gc... Dans le forum Awesome prints (Hall Of Fame)	il y a 8 years
	Thanks for the camera holder. I printed the spool holder and... Dans le forum Improvements (Archive)	il y a 8 years
	Great job, simple and effective...on a side note, where did ... Dans le forum Improvements (Archive)	il y a 8 years
	Not trying to jump in on this thread, but you were asking ab... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	I have the same issue using pronterface. I will set the new ... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	Are you sure the left side rod is pushed into the slot? The ... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	Going to assume this is new. I had same issue and was also a... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	Extruder Fan Wiring Error Dans le forum Prusa i3 kit (Archive)	il y a 8 years

Statistiques du forum

565 Forums

63.8 K Sujets

447.3 K Messages

19 En-ligne

69.4 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé