Prusa3D Forum

Notifications

Clear all

idontwantapublicusername

Groupe: Enregistré

A(ont) rejoint: 2021/04/18

Active Member

	I turned it on several times and it turned itself off again ... Dans le forum General discussion, announcements and releases	il y a 4 years
	Yes, results have been consistent so far. Also cleaned the i... Dans le forum How do I print this? (Printing help)	il y a 4 years
	Z variance wasn't a problem, I just posted in the wrong cate... Dans le forum How do I print this? (Printing help)	il y a 4 years
	The gap fill is between the hexagon perimeters and printed d... Dans le forum How do I print this? (Printing help)	il y a 4 years
	Oh that's weird... I thought the lack of adhesion was just a... Dans le forum How do I print this? (Printing help)	il y a 4 years
	That is true but I prefer the hotend to be cold while I have... Dans le forum Hardware, firmware and software help	il y a 4 years
	Thanks! I temporarily switched the thermistor with a potenti... Dans le forum Hardware, firmware and software help	il y a 4 years
	( Argh I broke my upload screen and ended up in the wrong pl... Dans le forum How do I print this? (Printing help)	il y a 4 years
	Severe nozzle pressure loss?/ underextrusion of infill after... Dans le forum How do I print this? (Printing help)	il y a 4 years
	Does the interface not respect M302? Dans le forum Hardware, firmware and software help	il y a 4 years
	Most version of prusaslicer have their conf in ~/.config/pru... Dans le forum Hardware, firmware and software help	il y a 4 years

Statistiques du forum

566 Forums

63.2 K Sujets

444.4 K Messages

25 En-ligne

68.2 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé