Prusa3D Forum

Benachrichtigungen

Alles löschen

idontwantapublicusername

Gruppe: Registriert

Beigetreten: 2021/04/18

Active Member

	I turned it on several times and it turned itself off again ... Im Forum General discussion, announcements and releases	Vor 4 years
	Yes, results have been consistent so far. Also cleaned the i... Im Forum How do I print this? (Printing help)	Vor 4 years
	Z variance wasn't a problem, I just posted in the wrong cate... Im Forum How do I print this? (Printing help)	Vor 4 years
	The gap fill is between the hexagon perimeters and printed d... Im Forum How do I print this? (Printing help)	Vor 4 years
	Oh that's weird... I thought the lack of adhesion was just a... Im Forum How do I print this? (Printing help)	Vor 4 years
	That is true but I prefer the hotend to be cold while I have... Im Forum Hardware, firmware and software help	Vor 4 years
	Thanks! I temporarily switched the thermistor with a potenti... Im Forum Hardware, firmware and software help	Vor 4 years
	( Argh I broke my upload screen and ended up in the wrong pl... Im Forum How do I print this? (Printing help)	Vor 4 years
	Severe nozzle pressure loss?/ underextrusion of infill after... Im Forum How do I print this? (Printing help)	Vor 4 years
	Does the interface not respect M302? Im Forum Hardware, firmware and software help	Vor 4 years
	Most version of prusaslicer have their conf in ~/.config/pru... Im Forum Hardware, firmware and software help	Vor 4 years

Forums-Statistiken

566 Foren

63.2 K Themen

444.2 K Beiträge

21 Online

68.1 K Mitglieder

Forum Icons: Das Forum enthält keine ungelesenen Beiträge Das Forum enthält ungelesene Beiträge

Themen-Icons: Unbeantwortet Beantwortet Aktiv Heiß Oben angepinnt Nicht genehmigt Gelöst Privat Geschlossen