Prusa3D Forum

Notifications

Clear all

idontwantapublicusername

Skupina: Registrovaný

Přidal se: 2021/04/18

Active Member

	I turned it on several times and it turned itself off again ... In forum General discussion, announcements and releases	před 4 years
	Yes, results have been consistent so far. Also cleaned the i... In forum How do I print this? (Printing help)	před 4 years
	Z variance wasn't a problem, I just posted in the wrong cate... In forum How do I print this? (Printing help)	před 4 years
	The gap fill is between the hexagon perimeters and printed d... In forum How do I print this? (Printing help)	před 4 years
	Oh that's weird... I thought the lack of adhesion was just a... In forum How do I print this? (Printing help)	před 4 years
	That is true but I prefer the hotend to be cold while I have... In forum Hardware, firmware and software help	před 4 years
	Thanks! I temporarily switched the thermistor with a potenti... In forum Hardware, firmware and software help	před 4 years
	( Argh I broke my upload screen and ended up in the wrong pl... In forum How do I print this? (Printing help)	před 4 years
	Severe nozzle pressure loss?/ underextrusion of infill after... In forum How do I print this? (Printing help)	před 4 years
	Does the interface not respect M302? In forum Hardware, firmware and software help	před 4 years
	Most version of prusaslicer have their conf in ~/.config/pru... In forum Hardware, firmware and software help	před 4 years

Fórum Statistiky

566 Fóra

63.2 K Témata

444.4 K Příspěvky

21 Online

68.2 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed