Notifications
Clear all
Ian Harris
Ian Harris
Group: Registered
Joined: 2022/02/23
Eminent Member
2
Like iftisbashir, I usually use gyroid infill - maybe rectil...

In forum Input Shaper (MK4)

5 months ago
No spatula on the USB drive that came with my Mk4:- Volume ...

In forum Hardware, firmware and software help

9 months ago
Quality rather than speed

In forum Input Shaper (MK4)

9 months ago
I've been using Transcend 16GB JetFlash 700 USB Flash Drive ...

In forum Hardware, firmware and software help

9 months ago
Yes, a time display similar to the Mk3 would be good, altern...

In forum Hardware, firmware and software help

10 months ago
I'm certainly no expert on firmware - perhaps the firmware f...

In forum General discussion, announcements and releases

10 months ago
The wifi module plugs in - so maybe there is a faster module...

In forum Hardware, firmware and software help

10 months ago
Firmware 4.6.1 - Mk3 gcode

In forum Hardware, firmware and software help

10 months ago
Firmware 4.6.1 now available for download. -- Ian

In forum General discussion, announcements and releases

10 months ago
Information on main screen

In forum General discussion, announcements and releases

11 months ago
I would agree - a z screw cover is needed. -- Ian

In forum General discussion, announcements and releases

11 months ago
Yes, eventually, it took a couple of tries with 3.12.1 , but...

In forum General discussion, announcements and releases

11 months ago
I would say the thermal modelling in 3.12 is still a beta th...

In forum General discussion, announcements and releases

11 months ago
Disable firmware update message?

In forum Hardware, firmware and software help

12 months ago
Two questions, if I may. 1) If the printer already has 3.12....

In forum General discussion, announcements and releases

12 months ago
Since installing v3.12.1.5686 and completing the thermal cal...

In forum General discussion, announcements and releases

1 year ago
3.12.1.5686 worked

In forum Hardware, firmware and software help

1 year ago
Well, success with v3.12.1.5686 firmware, although not quite...

In forum General discussion, announcements and releases

1 year ago
I would change the infill type (Gyroid maybe?), or change th...

In forum PrusaSlicer

1 year ago
I can understand a lot of work has gone into the v3.12 firmw...

In forum General discussion, announcements and releases

1 year ago
Page 1 / 2
Share: