|
After trying both 2.8.0 and 2.8.1, I've reverted to using 2.... In forum PrusaSlicer |
4 months ago |
|
I would agree - my Mk4 was purchased ready-built and has not... In forum General discussion, announcements and releases |
5 months ago |
|
Loaded 6.0.1, everything back to normal, no 'stuck filament'... In forum General discussion, announcements and releases |
5 months ago |
|
Loaded 6.1.2 and now I'm getting 'stuck filament' errors, wh... In forum General discussion, announcements and releases |
5 months ago |
|
2.8.0 seems like a bit of a disaster - I tried it, didn't li... In forum PrusaSlicer |
5 months ago |
|
Thanks - good to hear. -- Ian In forum General discussion, announcements and releases |
5 months ago |
|
Anyone been brave enough to try 6.1.2? I'm still on 6.0.1 as... In forum General discussion, announcements and releases |
5 months ago |
|
Like iftisbashir, I usually use gyroid infill - maybe rectil... In forum Input Shaper (MK4) |
1 year ago |
|
No spatula on the USB drive that came with my Mk4:- Volume ... In forum Hardware, firmware and software help |
2 years ago |
|
Quality rather than speed In forum Input Shaper (MK4) |
2 years ago |
|
I've been using Transcend 16GB JetFlash 700 USB Flash Drive ... In forum Hardware, firmware and software help |
2 years ago |
|
Yes, a time display similar to the Mk3 would be good, altern... In forum Hardware, firmware and software help |
2 years ago |
|
I'm certainly no expert on firmware - perhaps the firmware f... In forum General discussion, announcements and releases |
2 years ago |
|
The wifi module plugs in - so maybe there is a faster module... In forum Hardware, firmware and software help |
2 years ago |
|
Firmware 4.6.1 - Mk3 gcode In forum Hardware, firmware and software help |
2 years ago |
|
Firmware 4.6.1 now available for download. -- Ian In forum General discussion, announcements and releases |
2 years ago |
|
Information on main screen In forum General discussion, announcements and releases |
2 years ago |
|
I would agree - a z screw cover is needed. -- Ian In forum General discussion, announcements and releases |
2 years ago |
|
Yes, eventually, it took a couple of tries with 3.12.1 , but... In forum General discussion, announcements and releases |
2 years ago |
|
I would say the thermal modelling in 3.12 is still a beta th... In forum General discussion, announcements and releases |
2 years ago |
