Polski
Fora
Członkowie
Cotharyus
Aktywność
 
Notifications
Clear all
Cotharyus
Cotharyus
Grupa: Zarejestrowany
Dołączył: 2022/01/03
Active Member
1
Profil Aktywność
Thank you - that's much better than the scattered informatio...

In forum PrusaSlicer

 4 years temu
Machine Profile creation in Prusa Slicer - Primer available?

In forum PrusaSlicer

 4 years temu
There is an Ender 5 Plus profile in 2.4.0 - I'm running a Be...

In forum PrusaSlicer

 4 years temu
If it was just a LITTLE sticky, that could work. Unfortunate...

In forum Assembly and first prints troubleshooting

 4 years temu
Thank you for posting this. I've been struggling with prints...

In forum Assembly and first prints troubleshooting

 4 years temu
Good advice on the torch. I've got a big LED torch right on ...

In forum Assembly and first prints troubleshooting

 4 years temu
Thanks. I saw that dish soap and hot water was a good refres...

In forum Assembly and first prints troubleshooting

 4 years temu
Thank you. That is what I thought, but I couldn't find a way...

In forum Assembly and first prints troubleshooting

 4 years temu
Should have seen that coming - so, this is what the test loo...

In forum Assembly and first prints troubleshooting

 4 years temu
Two days in - a lot of questions.

In forum Assembly and first prints troubleshooting

 4 years temu
Understood. Thank you VERY much for taking the time to break...

In forum Assembly and first prints troubleshooting

 4 years temu
So, on the chance this is to me - I understand all of what y...

In forum Assembly and first prints troubleshooting

 4 years temu
That's a start. I did follow those steps, and feel like I ha...

In forum Assembly and first prints troubleshooting

 4 years temu
I have had some similar problems. I know everyone's calibrat...

In forum Assembly and first prints troubleshooting

 4 years temu
Share: