Prusa3D Forum

Notifications

Clear all

Cotharyus

Groupe: Enregistré

A(ont) rejoint: 2022/01/03

Active Member

	Thank you - that's much better than the scattered informatio... Dans le forum PrusaSlicer	il y a 4 years
	Machine Profile creation in Prusa Slicer - Primer available? Dans le forum PrusaSlicer	il y a 4 years
	There is an Ender 5 Plus profile in 2.4.0 - I'm running a Be... Dans le forum PrusaSlicer	il y a 4 years
	If it was just a LITTLE sticky, that could work. Unfortunate... Dans le forum Assembly and first prints troubleshooting	il y a 4 years
	Thank you for posting this. I've been struggling with prints... Dans le forum Assembly and first prints troubleshooting	il y a 4 years
	Good advice on the torch. I've got a big LED torch right on ... Dans le forum Assembly and first prints troubleshooting	il y a 4 years
	Thanks. I saw that dish soap and hot water was a good refres... Dans le forum Assembly and first prints troubleshooting	il y a 4 years
	Thank you. That is what I thought, but I couldn't find a way... Dans le forum Assembly and first prints troubleshooting	il y a 4 years
	Should have seen that coming - so, this is what the test loo... Dans le forum Assembly and first prints troubleshooting	il y a 4 years
	Two days in - a lot of questions. Dans le forum Assembly and first prints troubleshooting	il y a 4 years
	Understood. Thank you VERY much for taking the time to break... Dans le forum Assembly and first prints troubleshooting	il y a 4 years
	So, on the chance this is to me - I understand all of what y... Dans le forum Assembly and first prints troubleshooting	il y a 4 years
	That's a start. I did follow those steps, and feel like I ha... Dans le forum Assembly and first prints troubleshooting	il y a 4 years
	I have had some similar problems. I know everyone's calibrat... Dans le forum Assembly and first prints troubleshooting	il y a 4 years

Statistiques du forum

585 Forums

68.2 K Sujets

477.9 K Messages

9 En-ligne

75.9 K Membres

Le dernier des messages: Upgraded to PrusaSlicer 2.9.3 - Can't Upload GCode to OctoPrint anymore Notre nouveau membre: ArtiVIVO Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé