Čeština
Fóra
Uživatelé
Cotharyus
Aktivita
 
Notifications
Clear all
Cotharyus
Cotharyus
Skupina: Registrovaný
Přidal se: 2022/01/03
Active Member
1
Profile Aktivita
Thank you - that's much better than the scattered informatio...

In forum PrusaSlicer

 před 3 years
Machine Profile creation in Prusa Slicer - Primer available?

In forum PrusaSlicer

 před 3 years
There is an Ender 5 Plus profile in 2.4.0 - I'm running a Be...

In forum PrusaSlicer

 před 3 years
If it was just a LITTLE sticky, that could work. Unfortunate...

In forum Assembly and first prints troubleshooting

 před 3 years
Thank you for posting this. I've been struggling with prints...

In forum Assembly and first prints troubleshooting

 před 3 years
Good advice on the torch. I've got a big LED torch right on ...

In forum Assembly and first prints troubleshooting

 před 3 years
Thanks. I saw that dish soap and hot water was a good refres...

In forum Assembly and first prints troubleshooting

 před 3 years
Thank you. That is what I thought, but I couldn't find a way...

In forum Assembly and first prints troubleshooting

 před 3 years
Should have seen that coming - so, this is what the test loo...

In forum Assembly and first prints troubleshooting

 před 3 years
Two days in - a lot of questions.

In forum Assembly and first prints troubleshooting

 před 3 years
Understood. Thank you VERY much for taking the time to break...

In forum Assembly and first prints troubleshooting

 před 3 years
So, on the chance this is to me - I understand all of what y...

In forum Assembly and first prints troubleshooting

 před 3 years
That's a start. I did follow those steps, and feel like I ha...

In forum Assembly and first prints troubleshooting

 před 3 years
I have had some similar problems. I know everyone's calibrat...

In forum Assembly and first prints troubleshooting

 před 3 years
Share: