Italiano
Forum
Utenti
Cotharyus
Attività
 
Notifiche
Cancella tutti
Cotharyus
Cotharyus
Gruppo: Registrato
Registrato: 2022/01/03
Active Member
1
Profilo Attività
Thank you - that's much better than the scattered informatio...

Nel forum PrusaSlicer

 3 years fa
Machine Profile creation in Prusa Slicer - Primer available?

Nel forum PrusaSlicer

 3 years fa
There is an Ender 5 Plus profile in 2.4.0 - I'm running a Be...

Nel forum PrusaSlicer

 3 years fa
If it was just a LITTLE sticky, that could work. Unfortunate...

Nel forum Assembly and first prints troubleshooting

 3 years fa
Thank you for posting this. I've been struggling with prints...

Nel forum Assembly and first prints troubleshooting

 3 years fa
Good advice on the torch. I've got a big LED torch right on ...

Nel forum Assembly and first prints troubleshooting

 3 years fa
Thanks. I saw that dish soap and hot water was a good refres...

Nel forum Assembly and first prints troubleshooting

 3 years fa
Thank you. That is what I thought, but I couldn't find a way...

Nel forum Assembly and first prints troubleshooting

 3 years fa
Should have seen that coming - so, this is what the test loo...

Nel forum Assembly and first prints troubleshooting

 3 years fa
Two days in - a lot of questions.

Nel forum Assembly and first prints troubleshooting

 3 years fa
Understood. Thank you VERY much for taking the time to break...

Nel forum Assembly and first prints troubleshooting

 3 years fa
So, on the chance this is to me - I understand all of what y...

Nel forum Assembly and first prints troubleshooting

 3 years fa
That's a start. I did follow those steps, and feel like I ha...

Nel forum Assembly and first prints troubleshooting

 3 years fa
I have had some similar problems. I know everyone's calibrat...

Nel forum Assembly and first prints troubleshooting

 3 years fa
Condividi: