Prusa3D Forum

Notifications

Clear all

bicio2002

Grupa: Zarejestrowany

Dołączył: 2019/12/30

Active Member

	How long does a stock nozzle last? In forum Hardware, firmware and software help	5 years temu
	Had a successful long hours big part printing, I presume my ... In forum How do I print this? (Printing help)	5 years temu
	I made myself a question: what did change in the past weeks ... In forum How do I print this? (Printing help)	5 years temu
	@rudye-m The enclosure is made by 2 ikea lack tables, some p... In forum How do I print this? (Printing help)	5 years temu
	Same issue as here/p> checked out and cleaned everything as ... In forum How do I print this? (Printing help)	5 years temu
	Made some check this morning: grub screws ok, cleaned rods a... In forum How do I print this? (Printing help)	5 years temu
	I print prusament PETG only, that should have an higher melt... In forum How do I print this? (Printing help)	5 years temu
	Printing in progress at this time with open enclosure doors;... In forum How do I print this? (Printing help)	5 years temu
	As an additional consideration about the issue, I’m consider... In forum How do I print this? (Printing help)	5 years temu
	I disabled the filament sensor and I turned the print 90 deg... In forum How do I print this? (Printing help)	5 years temu
	Forgot to tell mine is a mk3s, I wrote here following a sear... In forum Others (Archive)	5 years temu
	It is happening to me as well; quite disturbing especially p... In forum Others (Archive)	5 years temu

Statystyki Forum

565 Fora

64.5 K Tematy

451.9 K Posty

26 Online

71.1 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte