Prusa3D Forum

Notifications

Clear all

bicio2002

Groupe: Enregistré

A(ont) rejoint: 2019/12/30

Active Member

	How long does a stock nozzle last? Dans le forum Hardware, firmware and software help	il y a 5 years
	Had a successful long hours big part printing, I presume my ... Dans le forum How do I print this? (Printing help)	il y a 5 years
	I made myself a question: what did change in the past weeks ... Dans le forum How do I print this? (Printing help)	il y a 5 years
	@rudye-m The enclosure is made by 2 ikea lack tables, some p... Dans le forum How do I print this? (Printing help)	il y a 5 years
	Same issue as here/p> checked out and cleaned everything as ... Dans le forum How do I print this? (Printing help)	il y a 5 years
	Made some check this morning: grub screws ok, cleaned rods a... Dans le forum How do I print this? (Printing help)	il y a 5 years
	I print prusament PETG only, that should have an higher melt... Dans le forum How do I print this? (Printing help)	il y a 5 years
	Printing in progress at this time with open enclosure doors;... Dans le forum How do I print this? (Printing help)	il y a 5 years
	As an additional consideration about the issue, I’m consider... Dans le forum How do I print this? (Printing help)	il y a 5 years
	I disabled the filament sensor and I turned the print 90 deg... Dans le forum How do I print this? (Printing help)	il y a 5 years
	Forgot to tell mine is a mk3s, I wrote here following a sear... Dans le forum Others (Archive)	il y a 5 years
	It is happening to me as well; quite disturbing especially p... Dans le forum Others (Archive)	il y a 5 years

Statistiques du forum

566 Forums

63.1 K Sujets

444 K Messages

24 En-ligne

68.1 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé