Prusa3D Forum

Benachrichtigungen

Alles löschen

bicio2002

Gruppe: Registriert

Beigetreten: 2019/12/30

Active Member

	How long does a stock nozzle last? Im Forum Hardware, firmware and software help	Vor 4 years
	Had a successful long hours big part printing, I presume my ... Im Forum How do I print this? (Printing help)	Vor 4 years
	I made myself a question: what did change in the past weeks ... Im Forum How do I print this? (Printing help)	Vor 4 years
	@rudye-m The enclosure is made by 2 ikea lack tables, some p... Im Forum How do I print this? (Printing help)	Vor 4 years
	Same issue as here/p> checked out and cleaned everything as ... Im Forum How do I print this? (Printing help)	Vor 4 years
	Made some check this morning: grub screws ok, cleaned rods a... Im Forum How do I print this? (Printing help)	Vor 4 years
	I print prusament PETG only, that should have an higher melt... Im Forum How do I print this? (Printing help)	Vor 4 years
	Printing in progress at this time with open enclosure doors;... Im Forum How do I print this? (Printing help)	Vor 4 years
	As an additional consideration about the issue, I’m consider... Im Forum How do I print this? (Printing help)	Vor 4 years
	I disabled the filament sensor and I turned the print 90 deg... Im Forum How do I print this? (Printing help)	Vor 4 years
	Forgot to tell mine is a mk3s, I wrote here following a sear... Im Forum Others (Archive)	Vor 4 years
	It is happening to me as well; quite disturbing especially p... Im Forum Others (Archive)	Vor 4 years

Forums-Statistiken

559 Foren

62.8 K Themen

442.4 K Beiträge

21 Online

67.4 K Mitglieder

Forum Icons: Das Forum enthält keine ungelesenen Beiträge Das Forum enthält ungelesene Beiträge

Themen-Icons: Unbeantwortet Beantwortet Aktiv Heiß Oben angepinnt Nicht genehmigt Gelöst Privat Geschlossen