Prusa3D Forum

Notifiche

Cancella tutti

AndrewD

Gruppo: Registrato

Registrato: 2017/09/24

Active Member

	I also noticed that the extruded stepper motor was significa... Nel forum Others (Archive)	7 years fa
	I agree. The printer's LCD seems to be correct and the seria... Nel forum Others (Archive)	7 years fa
	Had the same issue also. I assumed it was the filament senso... Nel forum Others (Archive)	7 years fa
	I had the same issue with the same firmware. I gave up and p... Nel forum Others (Archive)	7 years fa
	I had the same issue and again it was the connector on the b... Nel forum Others (Archive)	7 years fa
	Possible FW Bug- Stealth vs. Normal Mode 3.1.1-RC4 b143 Nel forum Others (Archive)	7 years fa
	Thanks for that. Lowering the height to about -1.1mm did imp... Nel forum Others (Archive)	7 years fa
	Thanks Thomas, I'm not convinced that test will show anythi... Nel forum Others (Archive)	7 years fa
	First, do an e-step calibration, extrude 100mm of filament a... Nel forum Others (Archive)	7 years fa
	Thanks Thomas, Will try and post the result. Nel forum Others (Archive)	7 years fa
	Prusa i3 MK3 Under Extrusion- First Layer Wizard Nel forum Others (Archive)	7 years fa

Statistiche Forum

565 Forum

63.9 K Discussioni

447.7 K Post

20 Online

69.5 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso