Prusa3D Forum

Notifications

Clear all

AndrewD

Group: Registered

Joined: 2017/09/24

Active Member

	I also noticed that the extruded stepper motor was significa... In forum Others (Archive)	7 years ago
	I agree. The printer's LCD seems to be correct and the seria... In forum Others (Archive)	7 years ago
	Had the same issue also. I assumed it was the filament senso... In forum Others (Archive)	7 years ago
	I had the same issue with the same firmware. I gave up and p... In forum Others (Archive)	7 years ago
	I had the same issue and again it was the connector on the b... In forum Others (Archive)	7 years ago
	Possible FW Bug- Stealth vs. Normal Mode 3.1.1-RC4 b143 In forum Others (Archive)	7 years ago
	Thanks for that. Lowering the height to about -1.1mm did imp... In forum Others (Archive)	7 years ago
	Thanks Thomas, I'm not convinced that test will show anythi... In forum Others (Archive)	7 years ago
	First, do an e-step calibration, extrude 100mm of filament a... In forum Others (Archive)	7 years ago
	Thanks Thomas, Will try and post the result. In forum Others (Archive)	7 years ago
	Prusa i3 MK3 Under Extrusion- First Layer Wizard In forum Others (Archive)	7 years ago

Forum Statistics

565 Forums

63.9 K Topics

447.7 K Posts

18 Online

69.5 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed