Prusa3D Forum

Benachrichtigungen

Alles löschen

AndrewD

Gruppe: Registriert

Beigetreten: 2017/09/24

Active Member

	I also noticed that the extruded stepper motor was significa... Im Forum Others (Archive)	Vor 7 years
	I agree. The printer's LCD seems to be correct and the seria... Im Forum Others (Archive)	Vor 7 years
	Had the same issue also. I assumed it was the filament senso... Im Forum Others (Archive)	Vor 7 years
	I had the same issue with the same firmware. I gave up and p... Im Forum Others (Archive)	Vor 7 years
	I had the same issue and again it was the connector on the b... Im Forum Others (Archive)	Vor 7 years
	Possible FW Bug- Stealth vs. Normal Mode 3.1.1-RC4 b143 Im Forum Others (Archive)	Vor 7 years
	Thanks for that. Lowering the height to about -1.1mm did imp... Im Forum Others (Archive)	Vor 7 years
	Thanks Thomas, I'm not convinced that test will show anythi... Im Forum Others (Archive)	Vor 7 years
	First, do an e-step calibration, extrude 100mm of filament a... Im Forum Others (Archive)	Vor 7 years
	Thanks Thomas, Will try and post the result. Im Forum Others (Archive)	Vor 7 years
	Prusa i3 MK3 Under Extrusion- First Layer Wizard Im Forum Others (Archive)	Vor 7 years

Forums-Statistiken

565 Foren

64.1 K Themen

449.1 K Beiträge

23 Online

70.2 K Mitglieder

Forum Icons: Das Forum enthält keine ungelesenen Beiträge Das Forum enthält ungelesene Beiträge

Themen-Icons: Unbeantwortet Beantwortet Aktiv Heiß Oben angepinnt Nicht genehmigt Gelöst Privat Geschlossen