Prusa3D Forum

Notifications

Clear all

AndrewD

Groupe: Enregistré

A(ont) rejoint: 2017/09/24

Active Member

	I also noticed that the extruded stepper motor was significa... Dans le forum Others (Archive)	il y a 7 years
	I agree. The printer's LCD seems to be correct and the seria... Dans le forum Others (Archive)	il y a 7 years
	Had the same issue also. I assumed it was the filament senso... Dans le forum Others (Archive)	il y a 7 years
	I had the same issue with the same firmware. I gave up and p... Dans le forum Others (Archive)	il y a 7 years
	I had the same issue and again it was the connector on the b... Dans le forum Others (Archive)	il y a 7 years
	Possible FW Bug- Stealth vs. Normal Mode 3.1.1-RC4 b143 Dans le forum Others (Archive)	il y a 7 years
	Thanks for that. Lowering the height to about -1.1mm did imp... Dans le forum Others (Archive)	il y a 7 years
	Thanks Thomas, I'm not convinced that test will show anythi... Dans le forum Others (Archive)	il y a 7 years
	First, do an e-step calibration, extrude 100mm of filament a... Dans le forum Others (Archive)	il y a 7 years
	Thanks Thomas, Will try and post the result. Dans le forum Others (Archive)	il y a 7 years
	Prusa i3 MK3 Under Extrusion- First Layer Wizard Dans le forum Others (Archive)	il y a 7 years

Statistiques du forum

565 Forums

63.9 K Sujets

447.7 K Messages

20 En-ligne

69.5 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé