Notifications
Clear all

Odd Behavior During XYZ calibration  

  RSS
ifoundgoldbug
(@ifoundgoldbug)
New Member
Odd Behavior During XYZ calibration

Greetings all,

We had a blob that took out the thermister and hot end. So after we replaced the parts we did a recalibrate and we are getting this strange behavior at point 3 Jump to 2:00 to see behavior.  It seems like the bed is too high in that corner but i can't seem to get it into flat.  Any help would be greatly appreciated.

This topic was modified 4 years temu by ifoundgoldbug
Opublikowany : 24/03/2020 2:50 pm
ifoundgoldbug
(@ifoundgoldbug)
New Member
Topic starter answered:
RE: Odd Behavior During XYZ calibration

Root cause was found to be loose 1 loose and 1 missing set screw on the X axis gt2-16 pulley. Whomever is reading this I hope that it helps.

Opublikowany : 30/03/2020 5:08 pm
Share: