Prusa3D Forum

Notifications

Clear all

wook1138

Grupa: Zarejestrowany

Dołączył: 2020/05/12

Active Member

	I'm following. I'm new to printing and just started with PE... In forum How do I print this? (Printing help)	4 years temu
	Filament sensor not working since last firmware update (?) In forum Hardware, firmware and software help	4 years temu
	@d-boath thanks! That is what I pretty much ended up doing.... In forum Assembly and first prints troubleshooting	4 years temu
	Well, the cold pull resulted in the filament breaking off in... In forum Assembly and first prints troubleshooting	4 years temu
	Thanks. Tried this. as I was trying to get a little play i... In forum Assembly and first prints troubleshooting	4 years temu
	Filament stuck in PTFE tube - won't extrude or unload In forum Assembly and first prints troubleshooting	4 years temu
	@bicio2002 Awesome to hear that! I’ve been problem free sin... In forum How do I print this? (Printing help)	5 years temu
	@johan I’m trying the print again. I disabled the filament s... In forum How do I print this? (Printing help)	5 years temu
	I just had the same thing happen to me (MK3S) - hour 8 of a ... In forum How do I print this? (Printing help)	5 years temu

Statystyki Forum

559 Fora

63.1 K Tematy

444 K Posty

21 Online

68 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte