Prusa3D Forum

Notifiche

Cancella tutti

wook1138

Gruppo: Registrato

Registrato: 2020/05/12

Active Member

	I'm following. I'm new to printing and just started with PE... Nel forum How do I print this? (Printing help)	5 years fa
	Filament sensor not working since last firmware update (?) Nel forum Hardware, firmware and software help	5 years fa
	@d-boath thanks! That is what I pretty much ended up doing.... Nel forum Assembly and first prints troubleshooting	5 years fa
	Well, the cold pull resulted in the filament breaking off in... Nel forum Assembly and first prints troubleshooting	5 years fa
	Thanks. Tried this. as I was trying to get a little play i... Nel forum Assembly and first prints troubleshooting	5 years fa
	Filament stuck in PTFE tube - won't extrude or unload Nel forum Assembly and first prints troubleshooting	5 years fa
	@bicio2002 Awesome to hear that! I’ve been problem free sin... Nel forum How do I print this? (Printing help)	5 years fa
	@johan I’m trying the print again. I disabled the filament s... Nel forum How do I print this? (Printing help)	5 years fa
	I just had the same thing happen to me (MK3S) - hour 8 of a ... Nel forum How do I print this? (Printing help)	5 years fa

Statistiche Forum

567 Forum

64.7 K Discussioni

453 K Post

21 Online

71.5 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso