Prusa3D Forum

Notifications

Clear all

wook1138

Groupe: Enregistré

A(ont) rejoint: 2020/05/12

Active Member

	I'm following. I'm new to printing and just started with PE... Dans le forum How do I print this? (Printing help)	il y a 4 years
	Filament sensor not working since last firmware update (?) Dans le forum Hardware, firmware and software help	il y a 4 years
	@d-boath thanks! That is what I pretty much ended up doing.... Dans le forum Assembly and first prints troubleshooting	il y a 4 years
	Well, the cold pull resulted in the filament breaking off in... Dans le forum Assembly and first prints troubleshooting	il y a 4 years
	Thanks. Tried this. as I was trying to get a little play i... Dans le forum Assembly and first prints troubleshooting	il y a 4 years
	Filament stuck in PTFE tube - won't extrude or unload Dans le forum Assembly and first prints troubleshooting	il y a 4 years
	@bicio2002 Awesome to hear that! I’ve been problem free sin... Dans le forum How do I print this? (Printing help)	il y a 5 years
	@johan I’m trying the print again. I disabled the filament s... Dans le forum How do I print this? (Printing help)	il y a 5 years
	I just had the same thing happen to me (MK3S) - hour 8 of a ... Dans le forum How do I print this? (Printing help)	il y a 5 years

Statistiques du forum

559 Forums

63.1 K Sujets

444 K Messages

22 En-ligne

68 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé