|
Yeah, I was thinking of the same thing myself, but I figured... In forum Hardware, firmware and software help |
3 years ago |
|
Save thermistor temperature offset in firmware? In forum Hardware, firmware and software help |
3 years ago |
|
T1 tool-change on a single-extruder, non-MMU MK3S+? In forum Hardware, firmware and software help |
3 years ago |
|
I'm not sure if that's applicable. I'm not getting thermal r... In forum Others (Archive) |
8 years ago |
|
Wildly fluctuating temperatures? In forum Others (Archive) |
8 years ago |
|
Do a forum search for "PID tune".
Peter
That did the trick... In forum Prusa i3 kit (Archive) |
8 years ago |
|
Yes, your filament has come loose from the bed. If you haven... In forum Prusa i3 kit (Archive) |
8 years ago |
|
Hotend temperature seesaw In forum Prusa i3 kit (Archive) |
8 years ago |
|
Yes, you just cut them or pry them loose. Sidecutters can be... In forum Prusa i3 kit (Archive) |
8 years ago |
|
It was printed with bridges.
Do you mean supports? If so, t... In forum Prusa i3 kit (Archive) |
8 years ago |
|
Only after XYZ-calibration, as far as I know. At least that'... In forum Prusa i3 kit (Archive) |
8 years ago |
|
Did you print the v2calibration.gcode after calibrating XYZ?... In forum Prusa i3 kit (Archive) |
8 years ago |
|
Tbh, I had more-or-less the same problem and all I had to do... In forum Prusa i3 kit (Archive) |
8 years ago |
|
Looks similar to what my prints exhibit, at least to my inex... In forum How do I print this? (Printing help) |
8 years ago |
|
After having played around with the belts, I'm not seeing an... In forum Prusa i3 kit (Archive) |
8 years ago |
|
There should be enough clues to make that decision.
Perhaps... In forum Prusa i3 kit (Archive) |
8 years ago |
|
X/Y belts too loose/tight; X/Y pulley with loose grub screw.... In forum Prusa i3 kit (Archive) |
8 years ago |
|
Ringing/banding issue In forum Prusa i3 kit (Archive) |
8 years ago |
