Prusa3D Forum

Notifications

Clear all

tom.h8

Grupa: Zarejestrowany

Dołączył: 2017/08/20

Active Member

	Filament stuck in nozzle In forum General discussion, announcements and releases	7 years temu
	The extra cold pulls worked - I've finished the print with ... In forum Prusa i3 kit (Archive)	7 years temu
	I loosened the tension from 14mm (as recommended in the trou... In forum Prusa i3 kit (Archive)	7 years temu
	I loosened the tension from 14mm (as recommended in the trou... In forum Prusa i3 kit (Archive)	7 years temu
	Just to clarify, the issue is still persisting. I'm going to... In forum Prusa i3 kit (Archive)	7 years temu
	Thanks Joan, I have sorted out the tangle: I had to cut out... In forum Prusa i3 kit (Archive)	7 years temu
	Extruder pulley eating into filament In forum Prusa i3 kit (Archive)	7 years temu
	Searching with those key words did it. The ones I used earli... In forum Prusa i3 kit (Archive)	7 years temu
	Extruder Jam In forum Prusa i3 kit (Archive)	7 years temu
	I've now managed to get the nozzle properly calibrated, and ... In forum Others (Archive)	7 years temu
	I've finally had some time to look at the printer again. I... In forum Others (Archive)	7 years temu
	Thanks for the reply; in my stress I missed the linked post.... In forum Others (Archive)	7 years temu
	Filament not pulling through In forum Others (Archive)	7 years temu

Statystyki Forum

565 Fora

63.7 K Tematy

447 K Posty

19 Online

69.2 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte