Prusa3D Forum

Notifiche

Cancella tutti

tom.h8

Gruppo: Registrato

Registrato: 2017/08/20

Active Member

	Filament stuck in nozzle Nel forum General discussion, announcements and releases	7 years fa
	The extra cold pulls worked - I've finished the print with ... Nel forum Prusa i3 kit (Archive)	7 years fa
	I loosened the tension from 14mm (as recommended in the trou... Nel forum Prusa i3 kit (Archive)	7 years fa
	I loosened the tension from 14mm (as recommended in the trou... Nel forum Prusa i3 kit (Archive)	7 years fa
	Just to clarify, the issue is still persisting. I'm going to... Nel forum Prusa i3 kit (Archive)	7 years fa
	Thanks Joan, I have sorted out the tangle: I had to cut out... Nel forum Prusa i3 kit (Archive)	7 years fa
	Extruder pulley eating into filament Nel forum Prusa i3 kit (Archive)	7 years fa
	Searching with those key words did it. The ones I used earli... Nel forum Prusa i3 kit (Archive)	7 years fa
	Extruder Jam Nel forum Prusa i3 kit (Archive)	7 years fa
	I've now managed to get the nozzle properly calibrated, and ... Nel forum Others (Archive)	7 years fa
	I've finally had some time to look at the printer again. I... Nel forum Others (Archive)	7 years fa
	Thanks for the reply; in my stress I missed the linked post.... Nel forum Others (Archive)	7 years fa
	Filament not pulling through Nel forum Others (Archive)	7 years fa

Statistiche Forum

565 Forum

63.7 K Discussioni

447 K Post

19 Online

69.2 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso