Prusa3D Forum

Notifications

Clear all

tom.h8

Skupina: Registrovaný

Přidal se: 2017/08/20

Active Member

	Filament stuck in nozzle In forum General discussion, announcements and releases	před 7 years
	The extra cold pulls worked - I've finished the print with ... In forum Prusa i3 kit (Archive)	před 7 years
	I loosened the tension from 14mm (as recommended in the trou... In forum Prusa i3 kit (Archive)	před 7 years
	I loosened the tension from 14mm (as recommended in the trou... In forum Prusa i3 kit (Archive)	před 7 years
	Just to clarify, the issue is still persisting. I'm going to... In forum Prusa i3 kit (Archive)	před 7 years
	Thanks Joan, I have sorted out the tangle: I had to cut out... In forum Prusa i3 kit (Archive)	před 7 years
	Extruder pulley eating into filament In forum Prusa i3 kit (Archive)	před 7 years
	Searching with those key words did it. The ones I used earli... In forum Prusa i3 kit (Archive)	před 7 years
	Extruder Jam In forum Prusa i3 kit (Archive)	před 7 years
	I've now managed to get the nozzle properly calibrated, and ... In forum Others (Archive)	před 7 years
	I've finally had some time to look at the printer again. I... In forum Others (Archive)	před 7 years
	Thanks for the reply; in my stress I missed the linked post.... In forum Others (Archive)	před 7 years
	Filament not pulling through In forum Others (Archive)	před 7 years

Fórum Statistiky

559 Fóra

62.9 K Témata

442.8 K Příspěvky

19 Online

67.6 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed