Prusa3D Forum

Notifications

Clear all

tom.h8

Groupe: Enregistré

A(ont) rejoint: 2017/08/20

Active Member

	Filament stuck in nozzle Dans le forum General discussion, announcements and releases	il y a 7 years
	The extra cold pulls worked - I've finished the print with ... Dans le forum Prusa i3 kit (Archive)	il y a 7 years
	I loosened the tension from 14mm (as recommended in the trou... Dans le forum Prusa i3 kit (Archive)	il y a 7 years
	I loosened the tension from 14mm (as recommended in the trou... Dans le forum Prusa i3 kit (Archive)	il y a 7 years
	Just to clarify, the issue is still persisting. I'm going to... Dans le forum Prusa i3 kit (Archive)	il y a 7 years
	Thanks Joan, I have sorted out the tangle: I had to cut out... Dans le forum Prusa i3 kit (Archive)	il y a 7 years
	Extruder pulley eating into filament Dans le forum Prusa i3 kit (Archive)	il y a 7 years
	Searching with those key words did it. The ones I used earli... Dans le forum Prusa i3 kit (Archive)	il y a 7 years
	Extruder Jam Dans le forum Prusa i3 kit (Archive)	il y a 7 years
	I've now managed to get the nozzle properly calibrated, and ... Dans le forum Others (Archive)	il y a 7 years
	I've finally had some time to look at the printer again. I... Dans le forum Others (Archive)	il y a 7 years
	Thanks for the reply; in my stress I missed the linked post.... Dans le forum Others (Archive)	il y a 7 years
	Filament not pulling through Dans le forum Others (Archive)	il y a 7 years

Statistiques du forum

559 Forums

62.9 K Sujets

442.8 K Messages

20 En-ligne

67.6 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé