Prusa3D Forum

Benachrichtigungen

Alles löschen

tom.h8

Gruppe: Registriert

Beigetreten: 2017/08/20

Active Member

	Filament stuck in nozzle Im Forum General discussion, announcements and releases	Vor 7 years
	The extra cold pulls worked - I've finished the print with ... Im Forum Prusa i3 kit (Archive)	Vor 7 years
	I loosened the tension from 14mm (as recommended in the trou... Im Forum Prusa i3 kit (Archive)	Vor 7 years
	I loosened the tension from 14mm (as recommended in the trou... Im Forum Prusa i3 kit (Archive)	Vor 7 years
	Just to clarify, the issue is still persisting. I'm going to... Im Forum Prusa i3 kit (Archive)	Vor 7 years
	Thanks Joan, I have sorted out the tangle: I had to cut out... Im Forum Prusa i3 kit (Archive)	Vor 7 years
	Extruder pulley eating into filament Im Forum Prusa i3 kit (Archive)	Vor 7 years
	Searching with those key words did it. The ones I used earli... Im Forum Prusa i3 kit (Archive)	Vor 7 years
	Extruder Jam Im Forum Prusa i3 kit (Archive)	Vor 7 years
	I've now managed to get the nozzle properly calibrated, and ... Im Forum Others (Archive)	Vor 7 years
	I've finally had some time to look at the printer again. I... Im Forum Others (Archive)	Vor 7 years
	Thanks for the reply; in my stress I missed the linked post.... Im Forum Others (Archive)	Vor 7 years
	Filament not pulling through Im Forum Others (Archive)	Vor 7 years

Forums-Statistiken

565 Foren

63.7 K Themen

447 K Beiträge

20 Online

69.2 K Mitglieder

Forum Icons: Das Forum enthält keine ungelesenen Beiträge Das Forum enthält ungelesene Beiträge

Themen-Icons: Unbeantwortet Beantwortet Aktiv Heiß Oben angepinnt Nicht genehmigt Gelöst Privat Geschlossen