Prusa3D Forum

Notifications

Clear all

Tigershark

Grupa: Zarejestrowany

Dołączył: 2020/10/24

Active Member

	Ok I haven't tried acetone. It just seems like this is too b... In forum How do I print this? (Printing help)	3 years temu
	It curled up on the corners again. 70c bed for first layer. In forum How do I print this? (Printing help)	3 years temu
	I considered ears on the corners, may do that. It's essentia... In forum How do I print this? (Printing help)	3 years temu
	Curling from print bed on large print In forum How do I print this? (Printing help)	3 years temu
	Certainly, the prints always seem to be really well adhered.... In forum Hardware, firmware and software help	4 years temu
	Top layer dragging in some spots In forum Hardware, firmware and software help	4 years temu
	Do you think it would be from the original stl file or somet... In forum Hardware, firmware and software help	4 years temu
	I can certainly understand adhesion and things like that but... In forum Hardware, firmware and software help	4 years temu
	Yes metal expands with heat and it's recommended you screw t... In forum Hardware, firmware and software help	4 years temu
	Print shifts 3 inches to the right halfway through In forum Hardware, firmware and software help	4 years temu

Statystyki Forum

559 Fora

62.9 K Tematy

442.9 K Posty

21 Online

67.7 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte