Prusa3D Forum

Notifications

Clear all

Tigershark

Groupe: Enregistré

A(ont) rejoint: 2020/10/24

Active Member

	Ok I haven't tried acetone. It just seems like this is too b... Dans le forum How do I print this? (Printing help)	il y a 3 years
	It curled up on the corners again. 70c bed for first layer. Dans le forum How do I print this? (Printing help)	il y a 3 years
	I considered ears on the corners, may do that. It's essentia... Dans le forum How do I print this? (Printing help)	il y a 3 years
	Curling from print bed on large print Dans le forum How do I print this? (Printing help)	il y a 3 years
	Certainly, the prints always seem to be really well adhered.... Dans le forum Hardware, firmware and software help	il y a 4 years
	Top layer dragging in some spots Dans le forum Hardware, firmware and software help	il y a 4 years
	Do you think it would be from the original stl file or somet... Dans le forum Hardware, firmware and software help	il y a 4 years
	I can certainly understand adhesion and things like that but... Dans le forum Hardware, firmware and software help	il y a 4 years
	Yes metal expands with heat and it's recommended you screw t... Dans le forum Hardware, firmware and software help	il y a 4 years
	Print shifts 3 inches to the right halfway through Dans le forum Hardware, firmware and software help	il y a 4 years

Statistiques du forum

559 Forums

62.9 K Sujets

442.9 K Messages

18 En-ligne

67.7 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé