Prusa3D Forum

Avisos

Vaciar todo

Tigershark

Grupo: Registrado

Registrado: 2020/10/24

Active Member

	Ok I haven't tried acetone. It just seems like this is too b... En el foro How do I print this? (Printing help)	hace 3 years
	It curled up on the corners again. 70c bed for first layer. En el foro How do I print this? (Printing help)	hace 3 years
	I considered ears on the corners, may do that. It's essentia... En el foro How do I print this? (Printing help)	hace 3 years
	Curling from print bed on large print En el foro How do I print this? (Printing help)	hace 3 years
	Certainly, the prints always seem to be really well adhered.... En el foro Hardware, firmware and software help	hace 4 years
	Top layer dragging in some spots En el foro Hardware, firmware and software help	hace 4 years
	Do you think it would be from the original stl file or somet... En el foro Hardware, firmware and software help	hace 4 years
	I can certainly understand adhesion and things like that but... En el foro Hardware, firmware and software help	hace 4 years
	Yes metal expands with heat and it's recommended you screw t... En el foro Hardware, firmware and software help	hace 4 years
	Print shifts 3 inches to the right halfway through En el foro Hardware, firmware and software help	hace 4 years

Estadísticas del Foro

559 Foros

62.9 K Temas

442.9 K Respuestas

20 En línea

67.7 K Miembros

Iconos del foro: El foro no contiene publicaciones sin leer El foro contiene publicaciones sin leer

Iconos de los Temas: No respondidos Respondido Activo Popular Fijo No aprobados Resuelto Privado Cerrado