Prusa3D Forum

Benachrichtigungen

Alles löschen

Tigershark

Gruppe: Registriert

Beigetreten: 2020/10/24

Active Member

	Ok I haven't tried acetone. It just seems like this is too b... Im Forum How do I print this? (Printing help)	Vor 3 years
	It curled up on the corners again. 70c bed for first layer. Im Forum How do I print this? (Printing help)	Vor 3 years
	I considered ears on the corners, may do that. It's essentia... Im Forum How do I print this? (Printing help)	Vor 3 years
	Curling from print bed on large print Im Forum How do I print this? (Printing help)	Vor 3 years
	Certainly, the prints always seem to be really well adhered.... Im Forum Hardware, firmware and software help	Vor 4 years
	Top layer dragging in some spots Im Forum Hardware, firmware and software help	Vor 4 years
	Do you think it would be from the original stl file or somet... Im Forum Hardware, firmware and software help	Vor 4 years
	I can certainly understand adhesion and things like that but... Im Forum Hardware, firmware and software help	Vor 4 years
	Yes metal expands with heat and it's recommended you screw t... Im Forum Hardware, firmware and software help	Vor 4 years
	Print shifts 3 inches to the right halfway through Im Forum Hardware, firmware and software help	Vor 4 years

Forums-Statistiken

559 Foren

62.9 K Themen

442.9 K Beiträge

20 Online

67.7 K Mitglieder

Forum Icons: Das Forum enthält keine ungelesenen Beiträge Das Forum enthält ungelesene Beiträge

Themen-Icons: Unbeantwortet Beantwortet Aktiv Heiß Oben angepinnt Nicht genehmigt Gelöst Privat Geschlossen