Prusa3D Forum

Notifications

Clear all

Tigershark

Skupina: Registrovaný

Přidal se: 2020/10/24

Active Member

	Ok I haven't tried acetone. It just seems like this is too b... In forum How do I print this? (Printing help)	před 3 years
	It curled up on the corners again. 70c bed for first layer. In forum How do I print this? (Printing help)	před 3 years
	I considered ears on the corners, may do that. It's essentia... In forum How do I print this? (Printing help)	před 3 years
	Curling from print bed on large print In forum How do I print this? (Printing help)	před 3 years
	Certainly, the prints always seem to be really well adhered.... In forum Hardware, firmware and software help	před 5 years
	Top layer dragging in some spots In forum Hardware, firmware and software help	před 5 years
	Do you think it would be from the original stl file or somet... In forum Hardware, firmware and software help	před 5 years
	I can certainly understand adhesion and things like that but... In forum Hardware, firmware and software help	před 5 years
	Yes metal expands with heat and it's recommended you screw t... In forum Hardware, firmware and software help	před 5 years
	Print shifts 3 inches to the right halfway through In forum Hardware, firmware and software help	před 5 years

Fórum Statistiky

585 Fóra

68.2 K Témata

477.5 K Příspěvky

11 Online

75.9 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed