sworcester – Aktivita – Prusa3D Forum

Notifications

Clear all

sworcester

Skupina: Registrovaný

Přidal se: 2017/02/03

Eminent Member

	Slow down the infill speed a little bit works well for me. ... In forum Others (Archive)	před 8 years
	I am printing and testing different infill patterns and came... In forum Others (Archive)	před 8 years
	PETG and renticular fill In forum Others (Archive)	před 8 years
	What is the number? Some tension, frequency? (My book only h... In forum Others (Archive)	před 8 years
	I made the mistake of starting an 11 hour print BEFORE upgra... In forum Others (Archive)	před 8 years
	My guess would be that the retraction settings are inaccurat... In forum Others (Archive)	před 8 years
	With RC5, I did not have infill problems with 15% honeycomb ... In forum Others (Archive)	před 8 years
	My guess would be that the retraction settings are inaccurat... In forum Others (Archive)	před 8 years
	Are you running the same speeds as RC4? RC5 disabled Linear ... In forum Others (Archive)	před 8 years
	New firmware print issues with Infill In forum Others (Archive)	před 8 years
	Im using a hardend steel nozzle from E3D, i cannot see any d... In forum Others (Archive)	před 8 years
	also have to be careful how much you tighten it. They su... In forum Others (Archive)	před 8 years
	320 mm. That, I had to look at my Misumi order PSFJ8-320/330... In forum Others (Archive)	před 8 years
	I was able to print PETG without any problem until the FW/SW... In forum Others (Archive)	před 8 years
	That is how it fit when I put the hot end in on my parts as ... In forum Others (Archive)	před 8 years
	It has gotten a little better in the latest firmware, but be... In forum Others (Archive)	před 8 years
	There is another thread on this, but essentially Update the... In forum Others (Archive)	před 8 years
	I figured out that turning on the auto load filament, remove... In forum Others (Archive)	před 8 years
	Possible workaround until this is fixed: Is there a "Move ex... In forum Others (Archive)	před 8 years

Stránka 2 / 3 Předchozí Další

Fórum Statistiky

585 Fóra

68.2 K Témata

477.7 K Příspěvky

14 Online

75.9 K Uživatelé

Poslední Příspěvek: A big piece disappears after slicing Nový Uživatel: mnentwig Recent Posts Unread Posts Tags

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed